SeaMount Twin Engine Bracket
with Swim Platform
Our SeaMount engine brackets, both single and twins, normally come with
a twenty nine inch setback which will allow any
V-6 to tilt completely out of
the water without hitting the transom of your
boat. They all come predrilled
for your engine and your transom. Each
twin engine bracket has two eight
inch access ports in the top and a 3/8ths inch
drain in the bottom.
All SeaMount brackets come standard with a baked on polyester
powdercoat on both the inside and outside as
well.
Each twin engine bracket with a swim platform is 84” wide and like the
basic twin bracket is rated for 500 horsepower.
These brackets weigh
approximately 175 lbs.
All of our SeaMount engine brackets are a full flotation design to help your
boat maintain the proper attitude when not
underway. These brackets almost
invariably will give at least some noticeable
increase in fuel economy and
performance, not to mention all the extra space
it will create in your boat.
Tired of fighting your old stern drive? Junk it! Join the thousands
who are
repowering with their choice of a new outboard
motor.
Click here for instructions on how to measure
your transom angle.