SeaMount Single Engine Bracket
with Swim Platform
Our SeaMount engine brackets normally come with a twenty nine inch
setback which will allow any V-6 to tilt
completely out of the water without
hitting the transom of your boat. They all come
pre-drilled for your engine
and your transom. Each single has one
eight inch access port in the top
and a 3/8ths inch drain in the bottom.
All SeaMount brackets come standard with a baked on polyester
powdercoating on both the inside and outside as
well.
Each single engine bracket with our standard 72” swim platform is rated at
250 horsepower and weighs approximately 105 lbs.
All SeaMount engine brackets are a full flotation design to help your boat
maintain the proper attitude when not
underway. These brackets almost
invariably will give at least some noticeable
increase in fuel economy and
performance, not to mention all the extra space
it will create in your boat.
Tired of fighting your old stern drive? Junk it! Join the thousands
who are
repowering with their choice of a new outboard
motor.
Click here for instructions on how to measure
your transom angle.