SeaMount Single Engine Bracket
Our SeaMount engine brackets normally come with a twenty nine
inch setback which will allow any V-6 to tilt
completely out of the water
without hitting the transom of your boat.
They all come pre-drilled for
your engine and your transom. Each single
has one eight inch access
port in the top with a 3/8ths drain in the
bottom.
All SeaMount brackets come standard with a baked on polyester
powdercoating on both the outside and inside as
well.
Each single engine bracket is rated at 250 horsepower and weighs
approximately 64 pounds.
All SeaMount engine brackets are a full flotation design to help your boat
maintain the proper attitude when not
underway. These brackets almost
invariably will give at least some noticeable
increase in fuel economy
performance, not to mention all the extra space
it will create in your boat.
Tired of fighting your old stern drive? Junk it! Join
the thousands
who are repowering with their choice of a new
outboard motor.
Click here for instructions on how to measure
your transom angle.